samsung rf32cg water filter manual

The Samsung RF32CG water filter is designed for Samsung refrigerators to provide clean, filtered water and ice. It effectively reduces contaminants including chlorine, lead, mercury, and other impurities. Compatible with select Samsung refrigerator models, this filter should be replaced every 6 months or 300 gallons for optimal performance. Below are key sections for installation, features, maintenance, troubleshooting, and specifications.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting to Refrigerator 7. Maintenance and Replacement 8. Water Quality Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Water filter cartridge, O-rings, installation instructions. Designed for easy replacement and compatibility with Samsung refrigerators.

Feature	Description
Filter Cartridge	Reduces contaminants like chlorine, lead, and mercury
O-rings	Ensures secure seal to prevent leaks
Installation Guide	Step-by-step instructions for replacement
Compatibility	For select Samsung refrigerator models
Filter Life Indicator	LED indicator on refrigerator for replacement reminder
Contaminant Reduction	Certified to NSF standards for water safety
Flow Rate	Maintains consistent water flow
Replacement Interval	Every 6 months or 300 gallons

Installation

Unpack and inspect contents. Ensure refrigerator is powered on and water supply is connected.

Locate filter compartment: Typically inside refrigerator or at the base.
Remove old filter: Turn counterclockwise and pull out gently.
Prepare new filter: Remove protective caps and align with compartment.
Insert new filter: Push in and turn clockwise until it locks.
Run water: Dispense 2-3 gallons to flush system and check for leaks.

WARNING! Do not overtighten filter; ensure O-rings are properly seated to prevent leaks.

First-Time Setup

After installation, reset filter indicator and test water flow.

Reset filter indicator: Press and hold FILTER button on control panel for 3-5 seconds.
Test water quality: Dispense water and check for clarity and taste.
Monitor performance: Ensure no leaks and proper flow rate.
Set reminder: Note installation date for future replacement.

CAUTION! Run water for several minutes to remove air from system and avoid sputtering.

Specifications

Model: Samsung RF32CG Water Filter
Compatibility: Select Samsung refrigerator models
Filter Life: 6 months or 300 gallons
Contaminants Reduced: Chlorine, lead, mercury, cysts, particulates
Certifications: NSF/ANSI 42 and 53
Flow Rate: Up to 0.5 gallons per minute
Operating Pressure: 30-120 psi
Storage Temperature: 40°F to 100°F (4°C to 38°C)

Controls and Settings

Filter status is managed via refrigerator control panel. No separate controls on filter itself.

Refrigerator Controls: FILTER button to reset indicator, WATER button to dispense, ICE button for ice maker.

Filter Indicator: LED light shows filter status (green for good, red for replacement). Reset by holding FILTER button. Water Dispensing: Press and hold for continuous flow. Ice Making: Ensure water supply is connected for ice production.

Connecting to Refrigerator

Filter connects to internal water line in refrigerator compartment.

Turn off water supply to refrigerator before installation.
Align filter with compartment and push until seated.
Turn clockwise to lock; do not force.
Restore water supply and check for leaks.

Tip: Use a towel to catch any water during installation.

Maintenance and Replacement

Replace filter every 6 months or when indicator light turns red.

Check indicator: Monitor LED status on control panel.
Purchase replacement: Use genuine Samsung RF32CG filter.
Follow installation steps: Remove old, install new.
Reset indicator: Hold FILTER button after replacement.
Record date: Note replacement for next cycle.

WARNING! Do not use damaged filters; replace immediately if cracked or leaking.

Water Quality Features

Certified to reduce specific contaminants for improved water taste and safety.

Contaminant	Reduction Rate
Chlorine	Up to 97%
Lead	Up to 99%
Mercury	Up to 96%
Cysts	Up to 99.9%
Particulates	Up to 95%

NSF certified for material safety and structural integrity.

Care & Cleaning

Wipe exterior of filter housing with damp cloth. Do not use chemicals or abrasive cleaners.

CAUTION! Do not attempt to clean or reuse filter cartridge; replace as scheduled.

Regulatory Information

Troubleshooting

Symptom	Possible Cause	Corrective Action
Water not dispensing	Filter not seated/water supply	Ensure filter locked; check water supply valve; reset indicator.
Leaking water	Loose filter/O-ring damage	Tighten filter; replace if O-ring damaged; check connections.
Poor water taste	Old filter/air in system	Replace filter; flush 2-3 gallons after installation.
Indicator not resetting	Button not held long enough	Hold FILTER button for 5 seconds; check power to refrigerator.
Low water pressure	Clogged filter/water pressure	Replace filter; check home water pressure (30-120 psi required).

Reset: Control panel > FILTER button > Hold 5 seconds.

Service: 1-800-SAMSUNG; www.samsung.com